Always the correct part In-House Experts. On the go Daily Deals Guaranteed Fitment.
![encore 5 class suction hose encore 5 class suction hose](https://images-na.ssl-images-amazon.com/images/I/5119f56-vcL._AC_SL1000_.jpg)
Clean the debris trays or baskets or deflectors in the recovery water tank after each use.This will help to prevent clogs from occurring and provide maximum suction to the squeegee assembly. Back flush the vacuum hose after each use. Simply run a broom handle down the hose to remove the clog, and then clean out the hose. Hoses can clog periodically when picking up large pieces of debris or operating on extremely dirty floors. This keeps tiny pieces of dirt and grit from accumulating and causing bad streaks.  A good habit to have is to wipe off the inside of the blades periodically while using the scrubber.  Remove the assembly and wash it thoroughly after each use.  Regular replacement will better insure a clean wipe by the blades.  Most squeegees can be removed and turned over to use the other side but eventually they all need to be replaced.  Worn or torn squeegees do not pick up water well.  This can create gaps between the squeegee and the floor surface leaving large streaks of water on the floor.  If an operator hit something with the assembly, it may have bent the bracket causing the squeegee to become out of line. The squeegee assembly should be completely level.  An air leak here and you won’t create a vacuum in the recovery water tank.  This can be a direct connection or through a hose. Make sure the vacuum motor is attached in some fashion to the recovery tank.Make sure the vacuum hose is attached to the recovery water tank at the other end.
![encore 5 class suction hose encore 5 class suction hose](https://i.ebayimg.com/images/g/ctEAAOSwmU5fqV~-/s-l400.jpg)
 Breaks in the hose allow for lost suction and bad water pickup.
![encore 5 class suction hose encore 5 class suction hose](https://gmauthority.com/blog/wp-content/uploads/2015/10/2016-Buick-Encore-12-1024x683.jpg)
 It is basically a vacuum motor pulling air and water through a hose attached to a squeegee on the rear of the scrubber. Vacuuming up the dirty water on an automatic scrubber hasn’t changed a whole lot since the machines were first developed. To recap, the first part is an overview of all the problems discussed and the second part is focused why your scrubber isn’t putting water down and if you’re reading this then you probably are either having issue with your scrubber not picking up water or are interested in learning some of the potential reasons for a scrubber leaving water behind.
ENCORE 5 CLASS SUCTION HOSE SERIES
This is part 3 of a 5 part series on common automatic floor scrubber problems.